Creating A Raid Driver Disk - Asus K8V SE User Manual

5.8

Creating a RAID driver disk

A floppy disk with the Promise
required when installing Windows
create a RAID driver disk using Makedisk.exe utility.
To create a RAID driver disk:
1. Insert the motherboard support CD into the CD-ROM drive and locate
the Makedisk.exe utility for your RAID controller.
A. The Makedisk.exe utility for the FastTrak 378 driver is located in
"\Drivers\Promise\378RAID\Makedisk.exe" of the motherboard
support CD.
B. The Makedisk.exe utility for the VIA RAID driver is located in
"\Drivers\VIARAID\6420RAID\DriverDisk\Makedisk.exe" of the
motherboard support CD.
2. Insert a clean floppy disk into the floppy disk drive and execute
Makedisk.exe. Follow succeeding screen instructions to complete the
process.
3. Write-protect the floppy disk to avoid computer virus infection.
To install the RAID driver:
1. During the OS installation, the system prompts to press the F6 key to
install third-party SCSI or RAID driver.
2. Press <F6> then insert the floppy disk with RAID driver into the floppy
disk drive.
3. Follow the succeeding screen instructions to complete the installation.
For additional information on RAID installation and configuration, refer
to the Promise
"\Drivers\Promise\Setup" or the VIA RAID readme file found in
"\Drivers\VIARAID\6420RAID\Readme.txt".
5-32
® SATA 378 or FastTrak 378 driver is
®
XP/2000 operating system. You can
®
RAID installation guide found in
Chapter 5: Software support