Sony ASH56NVIR Operating Instructions Manual page 9

Outdoor high-speed pan/tilt with infrared lighting

Table of Contents

Dome

Address DIP-1 DIP-2 DIP-3 DIP-4 DIP-5 DIP-6 DIP-7 DIP-8 DIP-9 DIP-10

OFF

...

1023

SW1 is used to set the addresses of the pan/tilt which has the range from 1 to 1023. From DIP-10 to DIP-1 it

corresponds to a binary number with 10 bits in which the highest bit is DIP-10 and the lowest bit is DIP-1. The

state ON for each bit means 1 while the state OFF means 0. The encodes of some addresses are as follows:

For example：

6 7

Speed Dome Address=1

6 7

Speed Dome Address=4

a. The address of the dome camera is set according to the binary coding system in which ON means "1" and

OFF means "0".

b. The coded addresses shown above are only from 1 to 18 and those from 19 to 1023 are and so forth.

d. Setup of the protocol: the protocol is set up by the first four bits of SW2 and the baud rate is set up by

the later two bits. Please refer to the following table and set the protocol and the baud rate to be identical

with that of the main machine.

5．Selection of the Protocol and the Default Baud Rate:

OFF

9 10

Speed Dome Address=2

9 10

Speed Dome Address=18

States of Dip-Switch

OFF

...

6 7

9 10

6 7

9 10

８

OFF

6 7

9 10

Speed Dome Address=3

6 7

9 10

Speed Dome Address=1023

Table of Contents