Table of Contents
Advertisement
screen are as follows:
The prompt messages are displayed on both op and bottom lines and information of every pattern is displayed in
the middle of the screen. One line includes data of two patrol positions. Move the cursor by PAN LEFT/RIGHT
and change values by TILT UP/DOWN. Press down buttons for more than one second to speed up operation.
Press CLOSE button to exit the Edit state and store the revisions. The program can search the first position where
POS is "---", and store data in front of it and regard data after it ineffective. Look the above drawing for example,
the program stores first four patrol positions. The settable range of POS is from 1 to 63 and 65 to 128. When POS
is "---", it means the range of the patrol is finished. The settable range of SP is from 0 to 8 (0 is the same with 1
and has the fastest speed while 8 has the lowest speed). The settable range of TM is from 0 to 99 seconds.
Operation of Title of Preset Position under Edit State. After entering into Edit state, the display on the screen
is shown as follows: from the drawing we can find the current setup is the
first preset position with the title of "NO TITLE". Move the cursor by PAN
LEFT/RIGHT and change values by TILT UP/DOWN. Press down buttons for
more than one second to speed up operation. Press CLOSE button to exit the
Edit state and store the revisions. The title of the preset position can include 8
characters in maximum such as 0-9, A-Z, +, - and blank. Note: the first letter
should be 0-9 or A-Z, otherwise it means the title of the preset position should be deleted. When calling the preset
position, it only displays "NO.XXX" without the title.
IV. Setup of the Intelligence Full-Dome Pan/Tilt
Before installing the product, first of all confirm the communication protocol and the baud rate of the main
machine in the system, then set the dip-switch SW2 of the pan/tilt to be identical with that of the system, set the
address of the pan/tilt on SW1 and the type of the communication protocol and the baud rate on SW2.
1. Terminal Resistor：
The jumper JP1 is the option switch of 120 Ω terminal resistor of the bus RS485. When it is at 2—3 state, 120
NO – No.of Patrol Position
POS – No.of Preset Position
SP – Leaving Speed
TM – Dwell Time
After entering into Edit state,following in-
formation displays on the screen:
EDIT AREA: one line includes data of two patrol positions.
SEQ:01
CLOSE:EXIT – Press CLOSE to exit Edit state
Dip-Switch of Address
（Figure 1）
– It means current set sequence is 1
Dip-Switch of Protocol
６
Advertisement
Table of Contents
