Table of Contents
Advertisement
6. Infrared System
a. The infrared system is normally under automatic control state. The infrared lamp shall act followed by
open/close of the low illumination of the camera;
b. The open/close state of the infrared lamp can be changed by the menu manually;
c. The default option on the menu of the infrared lamp is OFF. Normally the system detects external
illumination and opens/closes the infrared lamp automatically. If the user changes the option of the
infrared lamp into ON, the infrared system is changed into the manual control; if changing back into the
automatic control, the user should set the option on the menu of the infrared at OFF.
III. Setup of the Menu of the Pan/Tilt
1.
Basic Operation of the Menu
1.1
Open the main menu by the control keyboard or the matrix through the order "calling the 64th preset
position" or the order "calling the 1st preset position" in two fast and consecutive times.
1.2
When the menu is displayed on the screen, operate "TILT UP", "TILT DOWN" to move the cursor to the
option to be set; and operate "PAN LEFT", "PAN RIGHT" to modify contents or order to enter into the said
option.
1.3
To speed up operation by making the joystick towards one direction for more than one second.
1.4
All setup on the menu could not be lost even the power is failed.
1.5
Special uses can be seen from the description of the menu.
2.
Setup of the Menu
2.1 MAIN MENU
2.1.1
DISPLAY SETUP： To enter into the sub-menu of the display setup which
can set the ID display, title isplay of the presser position and the display of
the camera itself.
2.1.2
CAMERA SETUP： To enter into the sub-menu of the common data of the
camera.
2.1.3
CONTROL SETUP： To enter into the sub-menu of the control data of the
pan/tilt.
2.1.4
CAMERA MASK SET： To enter into the sub-menu of the control data of
the camera mask.
2.1.5
PROGRAM： To enter into the sub-menu of the enhance function of the menu.
2.1.6
PAL CAMERA： To switch modes of PAL/NTSC, being identical with that of the camera.
2.1.7
CAM DEFAULT SET： To recover to the default setup of the camera.
2.1.8
RESET PT： To reset the system.
2.1.9
EXIT： To exit the main menu.
2.2
DISPLAY SETUP
2.2.1
ID DISPLAY： when it is set at ON, the monitor shall display the address of
the pan/tilt such as "CAM 001". The default is ON when power supply is
switched on.
2.2.2
ID POS： to set the display position of the pan/tilt, which can be at four
corners of the screen such as TOP-L (upper left), TOP-R (upper right),
BOTT-R (bottom left) and BOTT-L (bottom right).
３
M A I N M EN U
1. D I SPLA Y SETU P
2. C A M ER A SETU P
3. C O N TR O L SETU P
4. C A M ER A M A SK SET
5. PR O G R A M
6. PA L C A M ER A
7. C A M D EFA U LT SET
8. R ESET PT
9. EXI T
DI SPLA Y SETU P
1. I D D I SPLAY O N
2. I D PO S
TO P- L
3. TI TLE DI S
O N
4. TI TLE PO S
01
5. CA M DI SPLAY O N
6. RETU RN
Advertisement
Table of Contents
