Pass-Through Panel Kit Mounting - Raymarine RAY50 Installation And Operation Instructions Manual

5.6 Pass-through panel kit mounting

When installing the Raymic handset or Fistmic use
the, pass-through panel kit to secure the cable
through a panel (e.g. bulkhead).
1
1
Splash-proof cap
2 Mounting screws x3
3 Mounting plate
4 Nut
5 Extension cable connector
1. Check the selected location for the handset
extension mounting plate, a clear flat area is
required.
2. Using a pencil, offer up the mounting plate to
the desired location and mark the location of the
screw holes and the center hole on the mounting
panel.
3. Drill the mounting holes using a suitable size drill
bit.
4. Drill the center hole using a 25 mm (1 in.) hole
cutting saw.
5. Pull the connector end of the cable through the
hole in the mounting panel.
6. With the recessed side facing away from the
mounting panel, place the mounting plate over
the end of the connector.
7. Place the ring end of the lanyard over the
connector, ensuring the lanyard sits in the recess
in the mounting plate.
8. Place the nut over the connector and tighten
clockwise using a 13/16 in. (21 mm) socket
wrench, being careful not to damage the nut by
overtightening.
9. Secure the mounting plate to the mounting
surface using the supplied screws.
10. Attach the handset / Fistmic connector to the
cable connector and rotate the locking collar
clockwise to secure.
11. Connect the opposite end of the cable to the
required connector either on the base station or
to another pass-through panel mounting plate
connector.
42
Note: Drill bit, tap size and tightening torque is
dependent on the thickness and type of material
the unit is to be mounted on.
D13304-1
Ray50 / Ray60 / Ray70