Raymarine RAY50 Installation And Operation Instructions Manual page 39

1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel
is required.
2. Fix the supplied mounting template to the
selected location, using masking or self-adhesive
tape.
3. Using a suitable hole saw (the size is indicated
on the template), make a hole in each corner of
the cut-out area.
4. Using a suitable saw, cut along the inside edge
of the cut-out line.
5. Ensure that the unit fits into the removed area
and then file around the rough edge until smooth.
6. Drill 4 holes as indicated on the template to
accept the fixings.
7. Remove the backings from the supplied gasket.
8. Place the gasket in position on the back of the
unit and press firmly onto the flange.
9. Connect the power, and other cables to the unit.
10. Slide the unit into place and secure using the
fixings provided.
11. Attach the mounting hole covers.
Location and mounting
Note: The supplied gasket provides a seal
between the unit and a suitably flat and stiff
mounting surface or binnacle. The gasket should
always be used. It may also be necessary to use
a marine-grade sealant if the mounting surface or
binnacle is not entirely flat and stiff or has a rough
surface finish.
D13207-1
D13208-1
39