Firmware Renewal Mode - FUNAI DR-A2601 Service Manual

1. Turn the power on and remove the disc on the tray.
2. To put the DVD recorder into version up mode,
press [CM SKIP], [6], [5], and [4] buttons on the
remote control unit in that order. Then the tray will
open automatically.
Fig. a appears on the screen and Fig. b appears
on the VFD.
* Firmware Version differs depending on the
models, and this indication is one example.
Firm Update Mode
Please insert a disc.
Fig. a Version Up Mode Screen
Fig. b VFD in Version Up Mode
3. Load the disc for version up.
Fig. c appears on the screen. The file on the top is
highlighted as the default.
When there is only one file to exist, Step 4 will
start automatically.
* Firmware Version differs depending on the
models, and this indication is one example.
Firm Update Mode
Disc name
VOL_200408250934
is displayed.
1 R2E2972S2S
2 R2E2973S2S
3 R2E2974S2S
4 R2E2975S2S
Fig. c Update Disc Screen

FIRMWARE RENEWAL MODE

ver. R2E2972S2S Current
F/W version
is displayed.
ver. R2E2972S2S
Files included
in the disc are
displayed.
1 / 1
4. Select the firmware version pressing arrow
buttons, then press [ENTER].
Fig. d appears on the screen and Fig. e appears
on the VFD. The DVD recorder starts updating.
About VFD indication of Fig. e:
1) When Fig. d is displayed on the screen, "F-UP"
is displayed on the VFD.
2) When "Firmware Updating... XX% Complete."
is displayed on the screen, "XX"% is displayed
on the VFD.
* Firmware Version differs depending on the
models, and this indication is one example.
Firm Update Mode
Selected
R2E2972S2S
F/W version
is displayed.
File Loading...
(*1)
Fig. d Programming Mode Screen
Fig. e VFD in Programming Mode (Example)
The appearance shown in (*1) of Fig. d is
described as follows.
No. Appearance
1 File Loading...
Firmware
2 Updating...
XX% Complete.
Firmware
---
Update Failure
1-7-1
ver.
R2E2972S2S
State
Sending files into the memory
Writing new version data
Failed in updating
E6820FW