Table of Contents
Advertisement
1. Turn the power on and remove the disc on the tray.
2. To put the DVD recorder into version up mode,
press [DVD], [CM SKIP], [6], [5], and [4] buttons on
the remote control unit in the order. Then the tray
will open automatically.
Fig. a appears on the screen.
* Firmware Version differs depending on the
models, and this indication is one example.
Firm Update Mode
Please insert a disc.
Fig. a Version Up Mode Screen
3. Load the disc for version up.
Fig. b appears on the screen. The file on the top is
highlighted as the default.
When there is only one file to exist, Step 4 will
start automatically.
* Firmware Version differs depending on the
models, and this indication is one example.
Firm Update Mode
Disc name
VOL_200612250934
is displayed.
1 WL4A10210S1E
2 WL4A10211S1E
3 WL4A10212S1E
4 WL4A10213S1E
Fig. b Update Disc Screen
FIRMWARE RENEWAL MODE
ver. WL4A*****S1E
Current
F/W version
is displayed.
ver. WL4A*****S1E
Files included
in the disc are
displayed.
1 / 1
4. Select the firmware version pressing arrow
buttons, then press [OK].
Fig. c appears on the screen. The DVD recorder
starts updating.
When "Firmware Updating... XX% Complete." is
displayed on the screen.
* Firmware Version differs depending on the
models, and this indication is one example.
Firm Update Mode
(*1)
File Loading...
Fig. c Programming Mode Screen
The appearance shown in (*1) of Fig. c is
described as follows.
No.
Appearance
1
File Loading...
Firmware
2
Updating...
XX% Complete.
Firmware
---
Update Failure
5. After updating is finished, the tray opens
automatically.
At this time, no button is available.
6. Pull out the AC code once, then insert it again.
1-9-1
ver. WL4A*****S1E
State
Sending files into the memory
Writing new version data
Failed in updating
E9E2ZFW
Advertisement
Table of Contents
