Configuring Load Balancing - Cisco RV180 Administrator's Manual

Configuring the Wireless Network (Cisco RV180W)

Configuring Load Balancing

STEP 4
STEP 1
STEP 2
Configuring Load Balancing
STEP 1
STEP 2
STEP 3
STEP 4
Cisco RV180/RV180W Administration Guide
Click Save.
You can manually add WDS peers that can connect to the Cisco RV180W:
In the WDS Peer Table, click Add.
Enter the MAC (hardware) address of the WDS peer and click Save.
You can configure load balancing on the Cisco RV180W to balance traffic
between the four available wireless networks to get optimal resource utilization,
throughput, or response time.
To configure load balancing:
Choose Wireless > Load Balancing.
Check Enable.
Under SSID Utilization Threshold, enter the utilization percentage for each SSID, or
network. When the network traffic exceeds that percentage, the Cisco RV180W
will direct traffic to one of the other networks whose threshold has not been
reached. The current utilization is displayed.
Click Save.
3
74