Cisco RV180 Administrator's Manual page 110

Configuring the Firewall
Firewall Configuration Examples
Cisco RV180/RV180W Administration Guide
Parameter
Finish
Send to Local Server (DNAT IP)
Rule Status
Example 3: Multi-NAT Configuration
In this example, you want to configure multi-NAT to support multiple public IP
addresses on one WAN port interface.
Create an inbound rule that configures the firewall to host an additional public IP
address. Associate this address with a web server on the DMZ. If you arrange with
your ISP to have more than one public IP address for your use, you can use the
additional public IP addresses to map to servers on your LAN. One of these public
IP addresses is used as the primary IP address of the router. This address is used
to provide Internet access to your LAN PCs through NAT. The other addresses are
available to map to your DMZ servers.
The following addressing scheme is used to illustrate this procedure:
• WAN IP address: 10. 1 .0. 1 18
• LAN IP address: 192. 1 68. 1 . 1 ; subnet 255.255.255.0
• Web server PC in the DMZ, IP address: 192. 1 68. 1 .2
• Access to Web server: (simulated) public IP address 10. 1 .0.52
Parameter
Connection Type
Action
Service
Source IP
Start
Send to Local Server (DNAT IP)
Rule Status
Value
134. 1 77.88.254
192. 1 68. 1 . 1 1
Enabled
Value
Inbound
Always Allow
HTTP
Single Address
10. 1 .0.52
192. 1 68. 1 .2 (local IP address of your web server)
Enabled
4
101