Advertisement
Installation
GB
! Before operating your new appliance please read this
instruction booklet carefully. It contains important information
for safe use, installation and care of the appliance.
! Please keep these operating instructions for future reference.
Pass them on to possible new owners of the appliance.
Positioning
! Keep packaging material out of the reach of children. It can
become a choking or suffocation hazard (see Precautions
and tips).
! The appliance must be installed by a qualified professional
according to the instructions provided. Incorrect installation
may cause harm to people and animals or may damage
property.
Built-in appliance
Use an appropriate cabinet to ensure that the appliance
operates properly.
• The supporting surface must be heat-resistant up to a
temperature of approximately 100°C.
• Avoid installing the hob above a dishwasher: if this
cannot be avoided, place a waterproof separation device
between the two appliances.
• Depending on the hob you want to install (see figure),
the cabinet must have the following dimensions:
TEPPAN YAKI UK
Installing semi-flush hobs
All the necessary precautions must be taken in order to
install the appliance in conformity with current accident-
prevention regulations (CEI-UNI-CIG) relating to gas and
electrical connections. To ensure sit-on hobs installed in
kitchen cabinets operate correctly, the minimum distances
indicated should be observed (see figure). All adjacent
surfaces and the back panel should also be able to
withstand an overheating temperature of 65°C.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
4
Securing the appliance to the cabinet
The appliance must be installed on a perfectly level
supporting surface.
Any deformities caused by improper fixing could affect the
features and operation of the hob.
• Before fitting the hob to the worktop, position the seal
provided along the perimeter of the hob, as illustrated in
the figure.
• The installation cavity should have the dimensions indicated
in the figure accompanying the previous paragraph.
Fix the hob as follows:
1. Use the screws supplied to fit the 4 alignment springs in
the holes provided at the central point of each side of the
part underneath the hob.
2. Place the hob in the cavity, make sure it is in a central
position and push down on the whole perimeter until the
hob is stuck to the supporting surface.
FRONT SIDE OF HOB
UNDERSIDE
OF HOB
700 min
50 min
SUPPORTIN G
SURFAC E
Advertisement
