Table of Contents
Advertisement
3.
To Adjust the Angle of Cut:
A. Loosen the Angle Knob (34c).
B. Pivot the Saw body in relation to the Foot (35c) to adjust the angle. Read the
angle from the arrow and scale near the Angle Knob.
C. Retighten the Angle Knob (34c) securely.
4.
To Adjust the Depth of Cut:
A. Be sure to keep your fingers well away from the Trigger (4c),
Safety (21c), and Blade (10c) while performing any adjustment,
but especially when adjusting the Depth, because the battery
may be installed.
B. Loosen the Depth Knob (34c).
C. Raise/lower the Saw body in relation to the Foot (35c) to adjust the depth.
Note: Add
D. Retighten the Depth Knob (34c) securely.
5.
Make certain that both halves of the workpiece are properly supported and secured
in place. Also, make sure that the path you will be cutting along is free from all
obstructions under/on the board and that there are no obstructions in the board itself
(such as knots or hardware).
Keep your fingers AWAY from the Trigger (4c) and Safety (21c) until
you are lined up with the board and ready to cut.
6.
Adjust the depth of cut to the shallowest setting. Insert the fully charged Battery (47)
in the Circular Saw's handle, and make sure it snaps into place on the handle. The
depth of cut can now be adjusted to the desired setting for use.
SKU 93816
For technical questions, please call 1-800-444-3353.
1
/
" to the depth so the Saw Blade (10c) can cut through the material cleanly.
8
Page 16
Hide quick links:
Advertisement
Table of Contents
