Table of Contents
Advertisement
4.
Insert the fully charged Battery (47) in the Drill's handle, and make sure it snaps into
place on the handle. The Battery can be rotated if needed to either allow better
balance or more clearance.
5.
Drilling Tips:
A. NEVER drill into areas where you cannot identify any possible hazards behind
the drilling surface.
B. Lubricate the cutting tip of the drill bit with cutting oil when drilling iron or steel.
Use a coolant when drilling nonferrous metals such as copper, brass, or alumi-
num.
C. When drilling in light gauge metal or wood, use a wooden block to back up the
material to prevent damage to the workpiece.
D. Mark the center of the hole to be drilled with a center punch to give a drill bit a
start and to prevent it from "walking".
E. To reduce jamming as the drill bit breaks through the workpiece, decrease the
drilling pressure when the point of the drill bit breaks through the workpiece.
F. Drill only as deep as necessary.
G. When you have drilled the hole, remove the drill bit from the hole while the Drill
is still running. This prevents the drill bit from getting caught in the hole and
causing damage.
6.
To turn on the Drill, squeeze the Trigger (18b). NOTE: Always grip the Drill firmly
with both hands when the tool is running.
7.
Release the Trigger (18b) to stop the Drill. Then, remove the Battery (47) and drill bit
from the Drill.
SKU 93816
For technical questions, please call 1-800-444-3353.
Page 14
Hide quick links:
Advertisement
Table of Contents
