Rail Assembly; Pulley Assembly - Genie Chain/Belt Drive Models Installation Manual

rAIl Assembly

(GrEEN BAG)
1a. Slide the powerhead end rail section (A) to correct position.
1b. Slide the door end rail section (C) to correct position.
1c. Lift powerhead rail section (A) slightly and slide rail connector (J) onto middle rail section (B).
1d. Lower powerhead rail end section (A) and slide into rail connector (J) until it locks.
1a.
DO YOU NEED AN EXTENSION KIT?
1g
Self-tapping screw
Drive gear
assembly*
A
*The drive gear assembly is loose and must be pulled towards the slots
and fastened. Be certain the tension bracket is hooked onto the rail
as shown in illustration 2c.
1. Check door height; doors taller than 7' up to 8' tall require a rail Extension Kit (available at leading retail stores)
2. If you need an extension kit, You MuST fullY read exTenSion KiT
A
B
NOTE: Check markings on carriage
to ensure it is pointing in the proper
1b.
direction with arrow pointing toward
DOOR (must match rail markings).
A
1c.
#8-3/4"
Slots
inSTrucTionS and warningS before proceeding.
1e. Lift door end rail section (C) slightly and slide rail connector (J) onto middle rail section (B).
1f. Lower door rail end section (C) and slide into rail connector (J) until it locks.
1g. Slide gear assembly to front end of powerhead end rail section (A). Ensure chain/belt is installed around gear.
Turn rail assembly over and place drive gear assembly in slots. Insert two screws to fasten assembly to the rail.
C
C
B
J
J
A
1d.
1f

PULLEY ASSEMBLY

SHOULD PULLEY PIN FALL OUT:
SIDE VIEW
Note orientation of pin.
It is inserted from the
bottom, head positioned
between rail and
pulley assembly.
Refer to illustration 2c.
HEAD
OF PIN
1e.
B
1f.
J
C
J
C