Table of Contents
Advertisement
5 - OPERATING INSTRUCTIONS
5-2C
A
5-2D
B
C
5-2E
5-2F
5-2G
5-2H
5-3. WARM ENGINE START
1.
Move ignition switch to the "RUN (I)" position.
2.
Place choke in START "
" position (Fig. 5-3).
3.
Grasp throttle handle firmly, squeeze throttle trigger to
FULL position.
4.
Pull starter rope briskly until engine starts, but no
more than 6 times. Keep throttle at FULL position until
engine runs smoothly.
5.
If engine does not start, place choke in RUN "
tion and pull starter rope 5 more times. If engine still
does not start it is probably flooded. Wait 5 minutes
and repeat procedure with choke in RUN "
and throttle full open.
5-3
5-4. TO STOP ENGINE
Release throttle trigger. Let engine return to idle. Move
switch to "STOP" position. (Fig. 5-4)
5-4
10
5-5. IDLING/CARBURETOR ADJUSTMENT
1. Occasionally, due to atmospheric conditions such as
altitude it might be necessary to make slight adjustment
to idle speed.
2. Insert phillips or flat screwdriver into access hole A (fig-
ure 5-5). Turn 1/8 turn clockwise to increase idle speed
and 1/8 turn counterclockwise to decrease idle speed.
" posi-
" position
6-1. ADDITIONAL SAFETY PRECAUTIONS
Before operating your unit, review ALL SAFETY PRECAU-
TIONS in this manual.
WARNING / CAUTION
•
IF UNFAMILIAR WITH TRIMMING techniques, prac-
tice the procedures with ENGINE in "OFF" position.
•
ALWAYS CLEAR WORK area of debris such as cans,
bottles, rocks, etc. Striking objects can cause serious
injury to operator or bystanders and also damage
equipment. If an object is accidentally hit, immediately
TURN ENGINE OFF and examine equipment. Never
operate unit with damaged or defective equipment.
•
ALWAYS TRIM OR CUT AT HIGH ENGINE SPEEDS.
Do not run engine slowly at start or during trimming
operations.
•
DO NOT use equipment for purposes other than trim-
ming or mowing weeds.
•
NEVER raise stringhead above knee height during
operation.
•
DO NOT operate unit with other people or animals in
the immediate vicinity. Allow a minimum of 50 feet (15
meters) between operator and other people and ani-
mals when trimming or mowing. Allow a distance of
100 feet (30 meters) between operator and other peo-
ple and animals when SCALPING with stringhead cut-
ting.
•
IF OPERATING UNIT ON A SLOPE, stand below the
cutting attachment. DO NOT OPERATE on a slope or
hilly incline if there is the slightest chance of slipping
or losing your footing.
5 - OPERATING INSTRUCTIONS
A
5-5
6 - TRIMMING INSTRUCTIONS
6-2. STRINGHEAD LINE RELEASE
WARNING / CAUTION
DO NOT use steel wire or plastic-coated steel wire of any
kind with your stringhead. Serious operator injury can
result.
To release fresh line, run engine at full throttle and "bump"
stringhead against lawn. Line will automatically release.
The knife in debris shield will trim excess line (Figure 6-2A).
CAUTION
Be sure engine is off and string head has stopped before
attempting to remove weeds wrapped around the shaft.
Periodically weeds will wrap around the shaft. They will
need to be removed or they will prevent the shaft from
being properly cooled and could result in damage. Use a
sharp object like a screw driver to remove them. (Fig. 6-2B)
11
BUMP
6-2A
6-2B
Advertisement
Table of Contents
