Related Manuals for Fisher-Price P7539
Summary of Contents for Fisher-Price P7539
- Page 1 P7539 WARNING IMPORTANT! KEEP INSTRUCTIONS FOR FUTURE REFERENCE. www.fi sher-price.co.uk...
-
Page 2: Consumer Information
(993532-P) Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran Tropicana Golf Country Resort, 47410 PJ. Tel: +603-3341 9052. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A. ©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. - Page 3 IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp CAUTION edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price for replacement parts and instructions if needed. ® Never substitute parts.
- Page 4 Assembly Crossbar Outside Holes • Insert two 8mm x 27mm screws into the outside holes in the side rails and tighten with the Allen wrench. Foot Tube Inside Holes • Turn the seat assembly upright. • At an angle, first insert one end of the crossbar into the groove in the side rail, as shown.
-
Page 5: Battery Installation
Assembly Battery Installation Fasteners Hint: We recommend using alkaline batteries for longer battery life. 1,5V x 3 “C” (LR14) Restraint Pad Waist Straps Fasteners Head Snuggler • Locate the battery compartment on the top of the soothing unit. • Loosen the screws in the battery compartment door. Lift to remove the battery compartment door. -
Page 6: Setup And Use
Setup and Use Securing Your Child WARNING Restraint Pad To prevent serious injury or death: • Fall Hazard - It is dangerous to use this product on an elevated surface, since child's movement may cause the product to slide or tip over. Use only on a fl oor. - Page 7 Infant Rocker or Stationary Seat Infant Rocker Stationary Seat • While pulling the latches toward you, lower the crossbar until it • While pulling the latches toward you, lift the crossbar until it “clicks” into place. “clicks” into place.
- Page 8 Soothing Unit Care • The pad and head snuggler are machine washable. Wash them separately in cold water on gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. • The frame and toy can be wiped clean using a mild cleaning solution and a damp cloth.