How To Attend To A Fault - Fisher & Paykel DishDrawer DD24DA User Manual

If it's a 'A' code
A1: Ensure the water supply
is on, press
the fault then press
resume the wash program.
A6: The Drawer indicator on
the drawer(s) with the fault
will flash. Open the drawer
and check the spray arm.
Has the spray arm loosened
or come off its mounting?
YES
Refit the spray
arm following
instructions in section
'User maintenance
instructions', then
close the drawer,
press again, then
press to resume
the wash program.
Has the fault code disappeared?
Has the dishwasher resumed
normal operation?
You have corrected the fault
and can continue to use your
dishwasher as normal.
28

HOW TO ATTEND TO A FAULT

START HERE
Press to stop the beeping.
Note down the fault code.
Look up the fault in the
table opposite.
again to clear
to
NO
YES
Press
then press
Has the fault code disappeared?
Disconnect the dishwasher from the
NO
power supply (unplug or switch off
at circuit breaker), turn off its water
supply, then contact Customer Care
with the fault code information. See
your 'Service and warranty' booklet
for contact details.
If it's an 'F' code
. Wait a few seconds,
again.
The fault has
reset. You can
continue to use
your dishwasher.
NO
YES