ECS GeForce 6100PM-M2 Manual page 37

IDE HDD Auto-Detection
Press <Enter> while this item is highlighted to prompt the Setup Utility to automati-
cally detect and configure an IDE device on the IDE channel.
If you are setting up a new hard disk drive that supports LBA mode, more
than one line will appear in the parameter box. Choose the line that lists
LBA for an LBA drive.
IDE Channel 0/2/3 Master & IDE Channel 0 Slave
Leave this item at Auto to enable the system to automatically detect and configure
IDE devices on the channel. If it fails to find a device, change the value to Manual
and then manually configure the drive by entering the characteristics of the drive in
the items described below.
Before attempting to configure a hard disk drive, ensure that you have
the configuration information supplied by the manufacturer of your
hard drive. Incorrect settings can result in your system not recognizing
the installed hard disk.
Access Mode (Auto)
This item defines ways that can be used to access IDE hard disks such as LBA (Large
Block Addressing). Leave this value at Auto and the system will automatically decide
the fastest way to access the hard disk drive.
Press <Esc> to return to the Standard CMOS Features page.
Drive A (1.44M, 3.5 in.)
This item defines the characteristics of any diskette drive attached to the
system.
Video (EGA/VGA)
This item defines the video mode of the system. The motherboard has a built-in
VGA graphics system; you must leave this item at the default value.
Halt On (All, But Keyboard)
This item defines the operation of the system POST (Power On Self Test)
routine. You can use this item to select which types of errors in the POST are
sufficient to halt the system.
Base Memory, Extended Memory, and Total Memory
These items are automatically detected by the system at start up time. These are
display-only fields. You cannot make changes to these fields.
Press <Esc> to return to the main menu setting page.
Using BIOS
31