Table of Contents
Advertisement
F After emptying the bottle, wipe away any
spillage around the tank filler using a damp
cloth.
If any additive is split or splashed, wash
immediately with cold water or wipe with
a damp cloth.
If the additive has crystallised, clean it
off using a sponge and hot water.
F Refit the blue cap to the tank and turn it a
6
of a turn clockwise, to its stop.
th
F Refit the black cap and turn it a quarter of
a turn clockwise without pressing. Ensure
that the indicator on the cap lines up with
the indicator on the support.
F Depending on equipment, return the spare
wheel and/or the storage box to the bottom
of the boot.
F Refit the boot carpet and close the tailgate.
Important: when topping up after
running out of additive, signalled
by the message "Top up emissions
additive: Starting prevented", you must
wait for approximately 5 minutes before
switching on the ignition, without
opening the driver's door, unlocking
the vehicle, placing the key of the
"Keyless Entry and Starting" system
inside the vehicle or inserting the
electronic key in the reader.
Switch on the ignition, wait for
10 seconds, then start the engine.
Never dispose of AdBlue
additive
®
bottles in the household waste. Place
them in a special container provided
this purpose or take them to your dealer.
Checks
8
327
Advertisement
Table of Contents
