Panasonic KX-HCM10 Operating Instructions Manual page 24

MAC address
Ethernet defines a 48-bit addressing scheme. Ethernet hardware
manufacturers purchase blocks of Ethernet addresses and assign them in
sequence to their Ethernet interface hardware. No two hardware interfaces
have the same Ethernet address. Ethernet address are sometimes called
hardware addresses, physical addresses, media access (MAC)
addresses, or layer 2 addresses. MAC address is used in this manual.
Notes
• Each Network Camera has a unique MAC address labeled on the back
as 00-80-f0-XX-XX-XX. ("X" is the number or alphabet of 0 – f.)
• The MAC address tells you which Network Camera you would like to
set up by confirming the rear side of the target Network Camera in case
there are many Network Cameras on the LAN.
• IP addresses of all Network Cameras connected to the LAN are
displayed.
• If the error message appears in Network Camera getting the IP
address, please do the following steps.
Error message
1. Disconnect the AC adapter of the Network Camera.
2. Please confirm if the cables on the network are connected properly.
3. Reconnect the AC adapter and run the Setup program again.
4. During this process the Ethernet indicator near the Ethernet port of the
24
Network Camera should be flashing.
Operating Instructions