Mazda 2009 MX-5 Miata Owner's Manual page 260

Interior Comfort
Audio System
(Registered ID code input preparation)
2. Hold the scan button, then press
channel preset button 6, hold both
buttons together for 1.5 seconds.
3. ENTER PIN appears for three
seconds which indicates that it is in
code input mode.
4. SR1 - - - - appears, which indicates
that it is ready for code input.
(Registered ID code input)
5. Input the registered ID code using
channel preset buttons 1-4. Example:
When the registered ID code is 2323 ,
input 2323 . At this time SR1 2323
is displayed.
NOTE
If "Err" is displayed, go to the
"INITIALIZATION OF ID CODE" section to
reset the ID code to [0000].
(Registered ID code input
determination)
6. Determine the input code by pressing
the scan button.
7. If it does not match the registered code,
SR1 Err is displayed and then it
returns to SR1 - - - - .
8. If it matches the registered code,
SR1 UNLOCK appears for three
seconds which indicates that the code
input has been completed.
9. SR1 100 appears which indicates that
the parental lock is off. At this time,
sound is heard.
6-44
NOTE
If an ID code is not input for ten seconds,
l
"Err" is displayed and it returns to the
former display.
Channel preset buttons 1, 2, 3, 4 and the
l
scan button are used for input of the ID
code. Buttons 5 and 6 cannot be used.
Error signs
(1) Depending on the surrounding
conditions (such as large trees,
buildings, or tunnels) and special
weather conditions, the reception of
SIRIUS radio waves may be
decreased or temporarily interrupted.
ACQUIRING may appear.
(2) In case of an antenna malfunction,
ANTENNA FAIL is displayed.
Check the satellite radio antenna,
antenna cable and DLP antenna
connector.
NOTE
If a broken DLP* unit is replaced with a new
unit, cancel the license for the broken unit and
make sure to carry out new registration for the
replaced unit. If the license for the broken unit
is not canceled, you will be charged a
reception fee for both units.
* DLP: Down Link Processor
(SATELLITE RADIO Module)