Mazda 2009 Mazda6 Owner's Manual page 261

2. "ENTER PIN" appears for 3 seconds
which indicates that it is in code input
mode.
3. "SR1 - - - -" appears, which indicates
that it is ready for code input.
4. Input the registered ID code using
channel preset buttons 1-4. Then press
the scan button.
Example: When the registered ID code
is "2323", input "2323". At this time
"SR1 2323" is displayed.
Press 1 for the first digit, 2 for the
second, 3 for the third, and 4 for the
last digit. For example, if your number
is 2323, press 1 three times, 2 four
times, 3 three, and 4 four times. If the
display goes off while inputting, begin
from Step 1.
NOTE
The registered ID code is the default [0000] at
the time of factory shipment. If [0000] results
in "Err" on the display, go to the
"INITIALIZATION OF ID CODE" section to
reset to [0000].
(Verification with the registered ID
code)
5. Determine the input code by pressing
the scan button.
6. If it does not match with the previously
registered code, "SR1 Err" is displayed
and then it returns to "SR1 - - - -".
7. If it matches with the previously
registered code, "ENTER PIN" appears
again and it switches to code input
mode.
8. "SR1 - - - -" appears, and it is ready for
input of the new ID code.
(New ID code input)
9. Input the new ID code using channel
preset buttons 1-4.
Example: If "1234" is input as the new
code, "SR1 1234" is displayed.
Press the scan button after the code is
input.
(New ID code input determination)
10. Determine the new ID code which
has been input by pressing the scan
button.
11. "PIN CHANGED" appears for 3
seconds which indicates that the new
ID code input has been completed.
12. It returns to the former display.
(How to clear the message)
Press any of the following FM/AM,
l
SAT, CD, AUX, LOAD, EJECT,
POWER buttons.
Turn the ACC off or insert a CD.
l
NOTE
If an ID code is not input for 10 seconds,
l
"Err" is displayed and it returns to the
former display.
Channel preset buttons 1, 2, 3, 4 and the
l
scan button are used for input of the ID
code. Buttons 5 and 6 cannot be used.
Individual channel locking
If a channel is locked, the channel is
muted.
NOTE
If the registered ID code is forgotten, return
the ID code to the default [0000]. (See
"INTIALIZATION OF ID CODE" section)
Interior Comfort
Audio System
6-43