Mazda 2009 Mazda6 Owner's Manual page 260

Mazda 2009 mazda6 automobile owner's manual
Table of Contents

Advertisement

Interior Comfort
Audio System
Initialization of ID code
If the registered ID code is forgotten,
return the ID code to the default [0000] by
performing the following steps:
Setting condition: SAT mode
(Master code input preparation)
1. Hold the scan button, then press
channel preset button 4, hold both
buttons together for 1.5 seconds.
2. "ENTER PIN" appears for 3 seconds
which indicates that it is in code input
mode.
3. "SR1 - - - -" appears, which indicates
that it is ready for code input.
(Master code input)
4. Input the master code using the channel
preset buttons 1-4.
Press the scan button inputting the
code.
(The master code is already set at the
time of factory shipment.)
(Master code input determination)
5. Determine the master code which has
been input by pressing the scan button.
6. "PIN CLEARED" appears which
indicates that the master code input has
been completed.
7. The ID code is set to the default [0000]
and the initialization process is
completed.
6-42
NOTE
Master code:
The Master Code is used to initialize or re-
initialize the ID code in the event that the code
is not set to [0000] and/or the personalized ID
code is not known. The initialization process
resets the ID code to [0000]. The master code
can potentially defeat the intent of the security
of the parental lock if it is located by persons
not authorized by the owner to access certain
channels.
SIRIUS Satellite Radio Master Code: [0913]
(How to clear the message)
Press any of the following FM/AM,
l
SAT, CD, AUX, LOAD, EJECT,
POWER buttons.
Turn the ACC off or insert a CD.
l
NOTE
When a numeric value other than the
l
master code is input and the scan button is
pressed, "SR1 Err" is displayed and then it
returns to the "SR1 - - - -" display again.
If an ID code is not input for 10 seconds,
l
"Err" is displayed and it returns to the
former display.
Channel preset buttons 1, 2, 3, 4 and the
l
scan button are used for inputting the ID
code. Buttons 5 and 6 cannot be used.
Change of ID code
Setting condition: SAT mode
When changing the ID code, the new ID
code is input after the previous one is
input first.
(Registered ID code input)
1. Hold the scan button, then press
channel preset button 5, hold both
buttons together for 1.5 seconds.

Advertisement

Table of Contents
loading

Table of Contents