For your
Before servicing or cleaning the unit, switch
power off at the service panel and lock the
safety
service panel to prevent power from being
switched on accidentally. If the service panel
cannot be locked, fasten a tag or prominent
warning label to the panel.
Metal
Clean the grease filter after 30 hours of "on"
time. A signal light will alert you when 30 hours
grease
has passed.
filter
Remove the grease filters and wash them
either by hand or in the dishwasher using
non-abrasive soap.
To clean, swish the filters in hot soapy water or
wash them in the dishwasher. Do not use abrasive
cleansers.
Hood
To clean the hood surface use hot soapy water,
then rinse and dry.
surfaces
For greasy soil use an all-purpose cleaning spray
such as Fantastik® brand or Formula 409® brand.
Light bulbs
To change the light bulbs:
1. Remove the trim ring by turning it
2. Grasp the bulb on the edges and pull it
3. Replace with the same size bulb.
6
counterclockwise.
straight out.
These 12 volt, 20 watt halogen bulbs are
available at specialty lighting stores. Ask for GE
bulb or equivalent: Q20MR16/C/CG40–BAB.
Care and Cleaning
Stainless Steel Hood
Note: To remove
filters push them
back and down
using the knob.
Front
For proper operation, be sure to
use the lower set of filter holders.
For hard to clean soil use a stainless steel cleaner
such as Bon-Ami®or Cameo® . Always scrub
lightly and with the grain.
Do not use steel wool pads or other abrasive
cleaners. They will scratch the surface.