Hoshizaki KM-100A Service Manual page 56

3) Remove the Top Cover and Front Cover. See Fig. 18.
4) Disconnect the Silicone Hose from the Spray Tube, and remove the Spray Tube
from the Evaporator Bracket.
5) Remove the Front Separator by pushing the Pins inserted into both sides of the
Evaporator Bracket toward the center. See Fig. 18.
Note: Be careful not to break the Pins.
6) The Rear Separator is hooked on the groove in the Evaporator Bracket. Remove the
Rear Separator by lifting it up and down. See Fig. 18.
7) Refit the Separators in the reverse order of the removal procedure. Check that the
Separators are fit correctly and can swing like a pendulum.
8) Plug in the icemaker or connect the power source.
Spray Tube
Front Separator
Top Cover
Silicone Hose
Pin
Front Cover
Rear Separator
53
Fig. 18