Denon AVR-1803 Operating Instructions Manual page 22

ENGLISH
2
Select the Dolby/DTS Surround mode.
(Main unit) (Remote control unit)
3
Play a program source with the
mark.
• The Dolby Digital indicator
DIGITAL
lights when playing Dolby
Light
Digital sources.
• The DTS indicator lights when
Light
playing DTS sources.
4 Set the surround parameter according to the source.
First, press the SURROUND PARAMETER button.
NOTE: Please make sure the "AUDIO" position of the slide switch on the remote
control unit.
(Remote control unit)
5
Use the
CINEMA EQ OFF
(Remote control unit)
Press the SURROUND PARAMETER or
COMP. setting.
(Remote control unit)
6
Use the
(Remote control unit)
Press the SURROUND PARAMETER or
LFE setting.
(Remote control unit)
NOTE: This parameter is not displayed during DTS playback.
22
When performing this operation from the main
unit's panel, press the SURROUND MODE
button, then turn the SELECT knob and select
Dolby Pro Logic or DTS NEO:6.
(Main unit)
Operate the SURROUND BACK button to
,
switch Surround Back CH ON/OFF.
Light
(Main unit)
• Lights when the SURROUND BACK button is
on.
(left) and (right) buttons to set the CINEMA EQ.
(Initial)
OFF ON
(left) button (right) button
(down) button to switch to the D.
(left) and (right) buttons to set the D. COMP.
(Initial)
OFF LOW MID
D.COMP. OFF
(left) button
(down) button to switch to the
7
(Remote control unit)
(Remote control unit)
8
(Remote control unit)
(Remote control unit)
(Remote control unit)
9
(Remote control unit)
HI
(right) button
Use the (left) and (right) buttons to set the LFE level.
LFE 0dB
• The level can be adjusted in units of 1 dB from –10 to 0 dB.
Set to the desired level according to the speaker systems being used and the
source to be played.
Press the SURROUND PARAMETER or (down) button to switch to the
default setting.
To reset the settings to the factory defaults, use the
display "Yes".
YES
DEFAULT Y/N
(left) button
Press the SURROUND PARAMETER or (down) button to switch to the
CINEMA EQ. setting.
Press the ENTER button to finish surround parameter mode.
(left) and (right) to
Y/N NO
(right) button