Table of Contents
Advertisement
PROBLEM
TINY SCRATCHES
OR ABRASIONS ON
RADIANT MODULE
GLASS SURFACE
METAL MARKINGS
DARK STREAKS
OR SPECKS
OVEN WILL
NOT WORK
OVEN DOES NOT
COOK PROPERLY
DOES NOT WORK
OVEN LIGHT DOES
NOT COME ON
OVEN WILL NOT
SELF-CLEAN
DOOR WON'T OPEN
AFTER SELF-CLEAN
CYCLE
"F-" AND A NUMBER
FLASH ON DISPLAY
If you need more help.. call, toll free:
GE Answer Center"
800.626.2000
consumer information service
—
POSSIBLE CAUSE AND REMEDY
Incorrect cleaning methods have been used or coarse particles (salt or sand)
between cookware and surface of cookware with rough bottoms have been used. Use
recommended cleaning procedure, be sure cookware bottoms and cookware are clean
before use, and use cookware with smooth bottoms. Tiny scratches are not removable
but will become less visible in time as a result of cleaning.
Do not slide metal objects across the surface. Use recommended cleaning
to remove
procedure
marks.
Plug on range is not completely inserted in the electrical outlet.
The circuit breaker in your house has been tripped, or a fuse has been blown.
Oven controls are not properly set.
Aluminum foil being used improperly in oven.
Incorrect cookware being used. Check each cooking section for cookware tips.
Oven controls set incorrectly.
Check the Baking, Roasting, and Broiling Guides in this book for problems
and technicmes.
Make sure the electrical plug is plugged into a live, properly grounded power outlet.
Check for power outage affecting your home.
Bulb may be loose or burned out, especially if the oven control/clock is working.
STOP TIME must be between 2 to 4 hours later than START TIME.
Oven temperature is too high to set self-clean operation. Allow the oven to cool to
room temperature and reset the controls.
If the self-cleaning mode malfunctions turn off and disconnect power supply.
Have the range serviced by a qualified technician.
When the temperature has fallen below the safe locking temperature (about 20-30
minutes after the oven goes off automatically), the door can be opened.
If the time display flashes "F-" and a number, you have function error code. Press
all power to the range. Call for service.
41
Advertisement
Table of Contents
