10. Single Band Operation; 11 Mhz Mode; 12 Channelized Frequency Display - Kenwood TH-78A Instruction Manual

•
To simultaneously receive two VHF band signals
1) Press the BAND key to select the UHF band.
2) Press the f
•
To simultaneously receive two UHF band signals
1) Press the BAND key to select the VHF band.
2) Press the f
Notes on simultaneous In-Band reception
1 When two signals on the same band are received simultaneously, the receive performance , such as
sensitivity, may be reduced.
2 If the two frequencies are the same, the volume may decrease at some VOL control positions.
To return to normal operation, press the f

10. Single Band Operation

When you press the DUAL key, the band for which the PTT indicator is on is selected, and you can perform a
single-band operation with that band.
When you press the BAND key, you toggle between single-band and dual-band operation.
11. MHz Mode
If you use this function, you can change the frequency in 1-MHz steps.
Press the MHz key.
The 100-kHz digit and lower digits of the operation band gl blank. When you turn the tuning control, the frequency
changes in 1-MHz steps.
To return to the normal frequency display, press any front panel key (except E. CHG key) or wait 10 seconds.

12 Channelized Frequency Display

The frequency display can be changed to display channel numbers instead of the operating frequency. This
function makes use of the data you have stored in memory for this functions. Channel 1 is memory channel 1,
Channel 2 is memory channel 2, etc.
2
key. The UHF band display also shows the second VHF band frequency.
2
key. The VHF band display also shows the second UHF band frequency.
2
key again.
Page 42