Table of Contents
Advertisement
Exact details on the connector, type of protection and matching mating connector
can also be found in data sheet 92512. The mating connector is not included in the
scope of delivery.
Procedure
1� Switch off the power supply to the relevant machine/system component.
2� Electrically connect the axial piston unit (12 or 24 V). Before establishing the
connection, check whether the connector protective covers have been removed
and the connector and all seals are intact.
Changing connector
If necessary, you can change the position of the connector by turning the solenoid
position
body. This is independent of the connector version.
CAUTION! Hot surfaces on the solenoid!
Risk of getting burnt!
▶ Allow the solenoid to cool down sufficiently before touching it.
▶ Wear heat-resistant, protective clothing, e.g. gloves.
To do this, proceed as follows:
2
1� Loosen the mounting nut (1) of the solenoid. To do this, turn the mounting
nut (1) one turn counterclockwise.
1
2� Turn the solenoid body (2) to the desired position.
3� Re-tighten the mounting nut. Tightening torque of the mounting nut: 5+1 Nm
(width across flats SW26, 12kt DIN 3124)�
7�5 Performing flushing cycle
In order to remove foreign particles from the system, Bosch Rexroth recommends
a flushing cycle for the hydraulic system before the first commissioning.
To avoid internal contamination, do not include the axial piston unit in the
flushing cycle.
Use an additional flushing unit to perform the flushing cycle.
Follow the instructions of the flushing unit's manufacturer for the exact
procedure during the flushing cycle.
Installation | A15VO/A15VLO series 12
RE 92512-01-B/2023-03-27, Bosch Rexroth AG
41/60
Advertisement
Table of Contents
