Table of Contents
Advertisement
For attachment via gear
wheel or helical gear shaft
No spline forces higher than the permissible axial and radial forces should act on
the shaft; if necessary, support the gear wheel at the gearbox output separately.
7�4�6 Installation with cardan shaft
Bring the axial piston unit to the installation position and fasten it.
Details of the required tools and tightening torque for the mounting bolts
can be obtained from the machine/system manufacturer.
NOTICE! Damage to the axial piston unit and leaks at the shaft seal due to
incorrectly installed cardan shaft!
Improperly installed cardan shafts generate unbalances. This results in vibrations
and inadmissible axial and radial forces on the drive shaft.
▶ Observe the cardan shaft manufacturer's assembly instructions.
7�4�7 Completion of installation
1� Remove any installed transport screws.
CAUTION! Operation with protective plugs!
Operating the axial piston unit with protective plugs may result in injury or
damage to the axial piston unit.
▶ Before commissioning, remove all protective plugs and replace them with
suitable, pressure-resistant, metal threaded plugs or connect the appropriate
lines.
2� Remove the transport protection.
The axial piston unit comes with protective covers (1) and protective plugs (2).
(1) and (2) are not pressure-resistant and have to be removed prior to
connection. Use a suitable tool for this to prevent damage to the sealing and
functional surfaces. If sealing or functional surfaces are damaged, contact your
Bosch Rexroth service partner or the service department of the manufacturer's
plant of the axial piston unit.
Installation | A15VO/A15VLO series 12
RE 92512-01-B/2023-03-27, Bosch Rexroth AG
33/60
Advertisement
Table of Contents
