Advertisement
Control and replacement of seals
BOWL GASKET (LOCATED AT THE REAR OF
BOWL)
Replace it every 12 months according to the
conditions of use and level of maintenance.
DISPENSE VALVE O-RING
The dispense valve o-rings should be replaced
as necessary when wear is evident. Lubricate
them each time they are replaced or the
dispense valve is removed for cleaning.
SUCTION GASKET
Replace every 3 months according to the
conditions of use and level of maintenance. This
part should be lubricated during the re-
assembly after every cleaning with Vaseline.
EVAPORATOR HARD SEAL AND ITS
SILICONE WASHER
Replace every 9 to12 months according to the
conditions of use and level of maintenance.
Winter storage
To protect the unit during seasonal shutdown,
it's important to properly store the machine
using the following procedures:
- Disconnect all power to the freezer.
- Disassemble, wash and sanitize all parts that
come into contact with the mix as described in
chapter 10.
- Clean also all the exterior panels.
- Reassemble all these parts.
- Cover the machine with the original package
to protect it from dust or other contaminating
elements.
- Place the machine in dry location.
Edition: 05/02/2024
10. SOFT SERVE ICE CREAM
INFORMATION
OVERRUN
While the product is frozen in the bowl, its
volume increase; to control overrun is important
as too much of it could go over the bowl
maximum level.
To correctly measure overrun carry out the
following steps:
- Place an empty container on the scale and
adjust your scale to zero;
- Remove the container from scale and fill it
with liquid product to the top. Weigh container
and record;
- Replace liquid product with frozen one, strike
off the excess of it so it is even with the top of
the container and measure the weight;
- Use the following formula to figure overrun
percentage:
"Weight of liquid mix minus weight of frozen
product divided by the frozen weight. Multiply
Example:
Weight of half litre of mix: 530g / 18.7oz;
Weight of half litre of frozen product: 380g
/13.4 oz;
Difference: 150g / 5.09 oz;
150/380=0.4
0.4x100=40% overrun
11. DISCLAIMER
The manufacturer declines all responsibility for
any damage that directly or indirectly might be
brought on to people, things, animals, as a
consequence of failure to comply with all
instructions given in this manual with the
warnings concerning installation procedures, use
and maintenance of the machine.
The manufacturer cannot be held responsible for
possible mistakes due to printing, copying or
translating errors contained in this manual.
In addition, the manufacturer reserves the right
to modify what deemed necessary or useful for
the machine, as well as for the benefit of the
user, yet at the same time maintaining the
essential operative and safety characteristics of
said machine.
Release: 0
by 100""
Pag. : 24/36
Advertisement
