Bosch RA1180 Operating/Safety Instructions Manual page 19

MOUNTING PLATE GUIDE FOR BOSCH ROUTERS (FIG. 18)
FIG. 18
FINAL INSTALLATION OF THE ROUTER
MOUNTING PLATE (FIG. 19)
1. Place the router mounting plate, with router
attached, on the leveling screws in the table top.
NOTE: Be careful not to trap the cord between the
router mounting plate and the router table top.
2. Recheck the router mounting plate to be sure it is
level. If necessary, loosen the locking nuts and
adjust the leveling screws with the allen wrench as
needed. Once the router mounting plate is level,
retighten the locking screws.
3. Secure the router mounting plate to the table top
with four #10-32 ESNA stop nuts (34) and four
#10-32 x 1" countersunk flat-head machine screws
(35). Be sure the screws are TIGHTENED
SECURELY.
TO REMOVE THE ROUTER AND/OR
ROUTER MOUNTING PLATE
To remove the router from the mounting plate, you must
first remove the router mounting plate from the router
table.
THE FENCE MUST BE REMOVED FROM THE
ROUTER TABLE WHEN REMOVING OR
RE-INSTALLING THE ROUTER MOUNTING PLATE.
Router Table Assembly
1619EVS
1601A, 1602A, 1604A
1613 SERIES
10-32 THREADED
INSERT FOR
STARTER PIN
GUARD
1617 SERIES
1601A, 1602A, 1604A
1619EVS
TOP FRONT OF PLATE
INSTALLING THE ROUTER MOUNTING PLATE
1613 SERIES
1617
SERIES
1619EVS
1601A, 1602A, 1604A
STARTER PIN HOLE
1617 SERIES
1601A, 1602A, 1604A
1613
1619EVS
SERIES
FIG. 19
#10-32 ESNA STOP NUTS
plugged into a power outlet when installing into the
table, removing from table, making adjustments or
changing accessories. Router could accidentally start.
1. Loosen the four #10-32 x 1" countersunk flat-head
machine screws (35) holding the router mounting
plate to the table top.
2. Lift the router mounting plate and router upwards
from the table top.
3. Remove the countersunk machine screws securing
the router to the mounting plate.
4. Be sure to check for levelness when reinstalling the
router mounting plate.
19
#10-32 x 1" COUNTERSUNK
FLAT HEAD SCREWS
Make sure that the router is NOT