Bosch RA1180 Operating/Safety Instructions Manual page 13

TOOLS REQUIRED (not included)
• Phillips screwdriver
• Small sized adjustable wrench
FENCE SUPPORT BRACKETS (FIG. 7)
1. Insert a #10-32 KEPS (31) nut into each of the
hex-shaped openings in the fence guides, with the
toothed washer facing towards the fence guide as
shown in Detail 7A.
NOTE: The KEPS nuts should "bottom-out" in the
hex-shaped openings on the fence guides. It may
be helpful to place the fence guides on a flat sur-
face and lightly tap the nuts in with a small hammer.
2. Attach the fence guides to the fence support
brackets using two #10-32 x 1/2" long truss head
machine screws (40), as shown in Fig. 7. DO NOT
tighten the screws at this time. The orientation of
the fence guide in relation to the fence support
bracket must be as shown.
3. Loosely assemble two 1/4-20 nuts (45) and 1/4-20 x
5/8" long truss head machine screws (43) to each
fence support bracket, as shown in Figure 7. It is not
necessary to tighten the fasteners at this time.
DUST COLLECTOR (FIG. 8)
1. Loosely attach a 1/4-20 hex nut (45), a 9/32" ID x
5/8" OD x 1/16" washer (36), and a 1/4-20 x 5/8"
lg. truss head machine screw (43) through the
holes on each side of the dust collector, as shown.
2. Slide the nuts into the T-slot on the back side of
the upper fence until the dust collector is centered
on the upper fence. Do not tighten completely at
this time.
ATTACH GUARD BRACKET TO UPPER
FENCE (FIG. 9)
1. Insert two 1/4-20 x 5/8" carriage bolts (38) through
the bottom of the guard bracket.
2. Slide a 9/32" ID x 5/8" OD x 1/16" washer (36)
onto each bolt, then loosely thread a 1/4-20 KEPS
nut (32) onto each bolt.
3. Slide the bolt heads into the top T-slot of the upper
fence, so that the raised key on the bottom of the
bracket fits into the T-slot and the vertical portion of
the bracket is flush with the back of the upper fence
(See Fig. 9).
4. Slide the bracket to the center of the upper fence
and loosely tighten the nuts to hold in place. DO
NOT tighten at this time.
Router Table Assembly
ASSEMBLING THE FENCE
FIG. 7
1/4-20
HEX NUTS
FENCE
SUPPORT
BRACKET
DETAIL 7A
FIG. 8
FIG. 9
GUARD
BRACKET
13
#10-32 KEPS NUTS
#10-32 KEPS
NUTS
1/4-20 HEX
NUTS
1/4-20 x 5/8"
CARRIAGE BOLT
1/4-20 x 5/8" MACHINE
SCREWS
#10-32 x 1/2"
MACHINE SCREWS
FENCE
GUIDE
FENCE
GUIDE
UPPER
FENCE
1/4-20 x 5/8"
MACHINE SCREWS
AND 9/32" ID x 5/8"
OD WASHERS
1/4-20 KEPS NUT
9/32" ID x 5/8" OD
WASHER
TOP T-SLOT
OF UPPER
FENCE
FRONT OF
UPPER
FENCE