Advertisement
Available languages
Available languages
TOOLS REQUIRED (not included)
• Allen wrench (included with router table)
• Phillips screwdriver
• Straight edge
• Small sized adjustable wrench
NOTE: The fences must NOT be installed on the router
table for the following procedures.
PRELIMINARY INSTALLATION OF THE
ROUTER MOUNTING PLATE
(FIGS. 15A –15D)
1. Completely thread a #10-32 ESNA stop nut (34)
onto each of the eight #10-32 x 3/4" countersunk
socket head screws (44) as shown in Fig. 15A. The
orientation of the stop nut on the screw must be as
shown in Fig. 15A.
NOTE: It will be helpful to use the included Allen
wrench and an adjustable wrench because the nut
has tight fitting threads.
2. Place the eight assembled screws and nuts into the
eight hex-shaped pockets in the recess on the table
top as shown in Fig. 15B.
The screw threads are to be inserted into the
holes at the bottom of the pockets.
3. Place the router mounting plate into the opening in
the table top so that it rests on the heads of the
screws as shown in Fig. 15B.
The mounting plate has a notch that matches
a positioning key on the router table so that
it will fit in one and only one way.
4. Position a straight edge or level across the mounting
plate as shown Fig. 15C. The straight edge must be
long enough to extend completely over the opening
in the router table top.
5. Insert the Allen wrench (47) through the eight
round holes in the mounting plate, engaging the
hex-socket in the screw heads (Fig. 15D).
6. Raise and lower the mounting plate by turning the
screws until the mounting plate is level and flush
with the top of the router table.
7. Remove the adapter plate from the table top.
8. Holding each screw in place with the Allen wrench,
thread a #10-32 KEPS nut (31) onto each screw
beneath the table as shown in Fig. 15D and
Detail15D. SECURELY tighten the nuts, taking
care not to turn the screws.
Turning these screws will affect the levelness of
the mounting plate.
Router Table Assembly
INSTALLING THE ROUTER MOUNTING PLATE
FIG. 15A
FIG. 15B
FIG. 15C
STRAIGHT EDGE
FIG. 15D
AREA OF
DETAIL 15D
NOTE: Not all eight screws and nuts shown
DETAIL 15D
NOTE: It may be necessary to make slight adjustments
after final installation of the router adapter plate.
17
#10-32 x 3/4" COUNTERSUNK
SOCKET HEAD SCREW
#10-32 ESNA STOP NUT
1/8" ALLEN WRENCH
1/8" ALLEN WRENCH
#10-32 KEPS NUT
Advertisement
