Table of Contents
Advertisement
Aligning the
Pulleys—Belt-drive Models
Models 68017C and 68021C only
1. Remove the divider plate; refer to
Divider Plate (page
2. Place a straightedge across the face of the engine pulley
and the idler pulley
1
Figure 66
1. Engine pulley
2. Idler pulley
3. Straightedge
Note: Both pulleys must be aligned flush with the
straightedge.
3. If the pulleys are not aligned do the following:
A. Move the clutch lever to the O
to
Controlling the Paddles (page
B. Loosen the locknuts and setscrews that secure the
idler pulley to the idler shaft
C. Using a soft-face mallet, tap the idler pulley
forward or backward along the idler shaft until
the engine pulley and the idler pulley are aligned
to the straight edge
D. Tighten the setscrews and locknuts that secure the
idler pulley to the idler shaft
4. Install the divider plate; refer to
Plate (page
28).
Removing the
28).
(Figure
66).
2
3
4
5
6
G020015
4. Idler shaft
5. Locknut
6. Setscrew
position; refer
FF
24).
(Figure
66).
(Figure
66).
(Figure
66).
Installing the Divider
Replacing the Light
Bulbs
Replacing the Rear-Facing
Taillight Bulbs
Note: The left rear-facing bulb also illuminates license plate.
1. Use a screwdriver to remove the 4 screws from the
large square lens on the light
A
B
D
E
2. Remove the lens
3. Push and twist the bulb counterclockwise to remove it
from the socket
4. Push a new 1157 bulb into the socket and then twist it
clockwise
(Figure
5. Install the lens and the 4 screws
Replacing the Side-Facing
Taillight Bulbs
1. Use a screwdriver to remove the 2 screws from the
small rectangular lens on the side of the light
68).
A
B
D
E
41
(Figure
67).
C
F
Figure 67
(Figure
67).
(Figure
67).
67).
(Figure
67).
C
F
Figure 68
G020829
(Figure
G020830
Advertisement
Table of Contents
