Table of Contents
Advertisement
Engine Controls
4
3
2
1
Figure 12
1. Recoil-start handle
2. Fuel valve
3. Choke lever
4. Throttle lever
Fuel Valve
The fuel valve
(Figure
13) is located underneath the choke
lever. Move the lever for the fuel valve to the O
before attempting to start the engine. When you have finished
mixing, shut off the engine and move the fuel-valve lever to
the O
position.
FF
1
2
Figure 13
1. Fuel valve
2. Choke lever
5
7
8
G019744
5. Fuel cap
6. Oil cap/dipstick
7. Oil-drain plug
8. On/Off switch
position
N
3
G018792
3. Throttle lever
Choke Lever
Use the choke lever
pulling the recoil-start handle, move the choke lever to the
closed position. Once the engine is running, move the choke
lever to the open position. Do not use the choke if the engine
is already warmed up or the air temperature is high.
Throttle Lever
The throttle lever
6
engine. It is located next to the choke lever. It sets the engine
speed and therefore can increase and decrease the rotation
speed of the mixing paddles. For best performance, set this
control to the fast position when mixing material.
Engine On/Off Switch
The O
/O
N
FF
machine to start and shut off the engine. This switch is
located on the front of the engine. Rotate the O
to the O
position to start and run the engine. Rotate the
N
O
/O
switch to the O
N
FF
OFF
1
1. O
position
FF
Recoil-Start Handle
To start the engine, pull the recoil-start handle
quickly to turn the engine over. The engine controls described
above must all be set correctly for the engine to start.
Oil-Level Switch
The oil-level switch is located inside the engine, and it does
not allow the engine to run in the event the oil level is below
the safe operating limit.
12
(Figure
13) to start a cold engine. Before
(Figure
13) controls the speed (rpm) of the
switch
(Figure
14) allows the operator of the
position to shut off the engine.
FF
2
Figure 14
2. O
position
N
/O
switch
N
FF
OFF
G021 103
(Figure
12)
Advertisement
Table of Contents
