Kenwood NEXEDGE NX-200 Function Reference page 559

APPENDIX
Available Functions for COM Port
Range
None
Data
GPS
Data + GPS Data Output
Transparent
Transparent 2 (NXDN)
RTS/CTS
Note
• "Data" and "Data + GPS Data Output" cannot be assigned to the different communication ports at the same time.
• "GPS" and "Data + GPS Data Output" cannot be assigned to the different communication ports at the same time.
• "Transparent" and "Transparent 2 (NXDN)" cannot be assigned to the different communication ports at the same time.
• Only if "Transparent" or "Transparent 2 (NXDN)" is assigned to the COM port 1, "RTS/CTS" can be assigned to the COM port 2.
• COM port 1 cannot be used while VGS-1 is in use.
• For Mobile, the PC command such as J Command which notifies a user that the transceiver status has been changed cannot be sent
from the COM port 0.
• The transceiver is equipped with a communication port on the connection of the internal PC board in the transceiver. Refer to the
service manual for details.
Configuration using KPG-111D/ DN
Assigning functions to the COM port (
FUNC (K)/Ver 4.00
Table 1-6 Available Functions for COM Ports
COM port 0
The transceiver can communicate with KPG-111D/ DN.
The transceiver can remotely be controlled using PC Commands.
The transceiver can communicate with KPG-111D/ DN.
-
The transceiver can remotely be controlled using PC Commands.
The transceiver will send GPS data by adding STX and ETX when the transceiver receives GPS data
from another transceiver.
The transceiver can communicate with KPG-111D/ DN.
-
-
-
FPRG 8.10.3 Common Page 3 Tab)
See
Communication Ports
COM port 1
Position data can be acquired from the GPS receiver unit. Also, the
transceiver can send the received GPS data when the transceiver
receives the GPS data from another transceiver.
The transceiver can communicate with KPG-111D/ DN.
The port functions as the data communication port for the
Transparent data communication using FleetSync protocol and
NXDN protocol.
The port functions as the data communication port for the
Transparent data communication using NXDN protocol which the
communication method is optimized. By using Transparent 2
(NXDN), data can be sent more efficiently than using Transparent.
-
CONTENTS
COM port 2
The port functions as the flow
control port for the Transparent
data communication.
INDEX 525