Kenwood NEXEDGE NX-200 Function Reference page 524

22 FUNCTION PORTS
22.2 D-sub 25-pin Connector (Mobile Only)
Migrating to a Zone-channel or GID by Using a Connected External Device
(Remote Zone-CH/GID)
Remote Zone-CH/GID can be used to migrate to one of a maximum of 15 Zone-channels or GIDs by using CH/GID Select
A to CH/GID Select D ports.
The transceiver migrates to the Zone-channel or GID registered in the Remote Zone-CH/GID List if one of the CH/GID
Select A to CH/GID Select D ports goes low level.
Table 22-10 Remote Zone-CH/GID List Number Corresponding to each CH/GID Select Port
Remote Zone-CH/GID
No.1
No.2
No.3
No.4
No.5
No.6
No.7
No.8
No.9
No.10
No.11
No.12
No.13
No.14
No.15
*1
Not Configured
*1
If no Remote Zone-CH/GID is configured, the transceiver cannot migrate to a Zone and channel or GID.
Note
A zone and channel or GID for which no channel or GID data is configured cannot be configured in the Remote Zone-CH/GID List.
Configuration using KPG-111D/ DN
• Assigning functions to the AUX Input Port (
• Configuring the Remote Zone-CH/GID List (
Optimizing the DI/ DEO Level
DI Level and DEO Level can be configured using KPG-111D/ DN.
DI Level
DI Level is the input signal level of the DI port available on the D-sub 25-pin connector of the transceiver. The input signal
level can be optimized according to the devices that are connected to the transceiver.
FUNC (K)/Ver 4.00
CH/GID Select D CH/GID Select C
High
High
High
High
High
High
High
Low
Low
Low
Low
Low
Low
Low
Low
High
FPRG 8.30.2 AUX Tab)
See
See FPRG 8.30.3 Remote Zone-CH/GID Tab)
AUX Input port
CH/GID Select B
High High
High Low
High Low
Low High
Low High
Low Low
Low Low
High High
High High
High Low
High Low
Low High
Low High
Low Low
Low Low
High High
CONTENTS
CH/GID Select A
Low
High
Low
High
Low
High
Low
High
Low
High
Low
High
Low
High
Low
High
INDEX 490