Bosch BDU314Y Owner's Manual page 197

English – 6
ference to radio communications. However, there is
no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following mea-
sures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
– Consult the dealer or an experienced radio/TV tech-
nician for help.
Radiofrequency radiation exposure Information:
The radiated output power of the device is far below
the FCC radio frequency exposure limits. Neverthe-
less, the device shall be used in such a manner that
the potential for human contact during normal opera-
tion is minimized.
This equipment complies with FCC radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and
your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or
transmitter.
ISED Notice (Canada)
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two con-
ditions:
1. this device may not cause interference, and
2. this device must accept any interference, including
interference that may cause undesired operation
of the device.
This equipment complies with Canada radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
0 275 U07 3BI | (03.03.2023)
minimum distance of 20 cm between the radiator and
your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or
transmitter.
Certification information: For FCC- and IC-ID press
and hold Bluetooth® button until <Certifications>
appears on the display. Release Bluetooth® button
and FCC-ID appears. Another short press of
Bluetooth® button shows IC-ID.
Privacy notice
When connecting the eBike to the Bosch Diagnostic-
Tool 3 or when exchanging eBike components, tech-
nical information about your eBike (e.g. manufac-
turer, model, bike ID, configuration data) as well as
regarding the use of the eBike (e.g. total travel time,
energy consumption, temperature) is transmitted to
Bosch eBike Systems (Robert Bosch GmbH) for pro-
cessing your request, in service cases and for the pur-
poses of product improvement. More information on
data processing can be found at
www.bosch-ebike.com/privacy-full.
Bosch eBike Systems