Table of Contents
Advertisement
en
28 | TCE 4225 | Initial commissioning
4.2.5
Mounting the bead breaker arm
1. Remove the external elastic ring and take off the hin-
ge rod from its housing in the bead breaking arm.
2. Remove the self locking nut.
3. Insert the bead breaking arm and centre the joint pin
with the bead breaking cylinder, ensuring that the
flat part of the joint pin (1) is facing the outside.
4. Insert the hinge-pin and put back in place the exter-
nal elastic ring.
5. Place the buffer spring on the provided tab and
screw in the bead breaking cylinder the self locking
nut.
Danger!
Wrong mounting of the bead breaking cylin-
der compromises machine functioning and
can be a serious danger for the operator.
€
During machine installation be sure that
the nut is correctly screwed in the bead
breaking cylinder rod (at least 10 mm).
|
1 695 105 431
2010-02-16
4.2.6
1. Install the air tank behind the column by fitting the 2
provided screws.
1
2. Insert the rubber pipe in the tank joint and fasten
the hose clamp.
3. Connect the gauge support to the column with the 2
provided screws.
Mounting of the inflation device for tubeless
tires
2
3
Robert Bosch GmbH
Advertisement
Table of Contents
