Table of Contents
Advertisement
4.2.3
Column fixing
1. Fix the column to the casing with the screws contai-
ned in the provided accessories box.
4.2.4
Positioning the vertical rod
1. Use the locking lever to unlock the vertical rod (1),
lift by about 10 cm and block it again.
2. Unscrew the cap on top of the rod with a wrench
(2).
2
1
Robert Bosch GmbH
Initial commissioning | TCE 4225 | 27
!
Warning: when unlocking the rod keep a hand under-
neath it.
3. Remove the rod; remove the spring and put again the
rod in its original seat, locking it at the end stop.
4. Insert the spring in the upper part of the rod and
screw again the cap with the wrench.
Danger!
The spring could eject violently the rod from
its housing, thus it might be a serious danger
for the operator.
€
Carry out this operation carefully.
en
|
1 695 105 431
2010-02-16
Advertisement
Table of Contents
