Network Time; Remote; Remote Update - Miele PDR 914 HP Operating And Installation Instructions

Supervisor level
The network is no longer set up. A new connection has to be established in order to use
the network again.
– The WiFi is switched off.
– The WiFi connection will be reset to the factory default setting.

Network time

The date and time can be synchronised over the network.
- Off
The date and time are not synchronised over the network.
- As master
The machines are in a network but are not connected to the Internet. A machine is de-
clared as the master and sends data to the slave devices.
- As slave
The machines are in a network and are connected to the Internet. All machines are con-
figured as slaves. Data is synchronised over the Internet.

Remote

External programme selection is possible via an external terminal (programme may only
be started on the machine). However, programmes may also be selected and started on
the machine.
Factory default: on

Remote Update

The RemoteUpdate function is used for updating the software in your tumble dryer.
RemoteUpdate is activated by default.
If you do not install a RemoteUpdate, you can continue to use your tumble dryer in the
usual way. However, Miele recommends installing RemoteUpdates.
Miele's RemoteUpdate function can only be used if the tumble dryer is connected to a
WiFi/LAN network and you have an account in the Miele Professional app. The tumble
dryer must be registered in the app.
See the Miele Professional app for terms of use.
If a RemoteUpdate is available for your washing machine, it will be displayed automatically
when the Operator level is open.
You can choose to start the RemoteUpdate immediately or wait until later. If you select
"Start later", the prompt to run the RemoteUpdate will be displayed again the next time you
switch on your washing machine.
The RemoteUpdate can take a few minutes.
Please note the following information about the RemoteUpdate function:
- You will only receive a message when a RemoteUpdate is available.
- Once a RemoteUpdate has been installed, it cannot be undone.
56