Table of Contents
Advertisement
3. Use your thumb or forefinger to press the ejector and locking lever on the hard-disk drive
that you are removing to eject the hard-disk drive from the chassis.
4. Gently pull the hard-disk drive forward to remove it from the appliance.
5. Insert the new hard-disk drive until it locks into place.
The ejector and locking lever clicks into the locked position.
6. Tighten the retaining screws on both sides of the hard-disk drive.
7. Press the hot swap button to restore power to the hard-disk drive.
The IP1200 Series recognizes the new hard-disk drive.
8. Use Nokia Network Voyager, Lynx, or the CLI to implement disk mirroring.
IP1220 and IP1260 Security Platforms Installation Guide
All manuals and user guides at all-guides.com
Push red
button to
disengage
lock
Replacing a Hard-Disk Drive
Release
or lock
into place
00316.2
00320
87
Advertisement
Table of Contents
