Nokia 7210 Configuration Manual page 684

Appendix: 7210 SAS Boot Procedures
Table 96
Note: Console outputs shown in this chapter are examples only; actual displays may differ
depending on the 7210 SAS platform, supported functionality, and user configuration.
684
7210 SAS Boot Procedure Overview
Section
Procedure to Boot Using
Auto-init Mode
Procedures to Boot Using
Manual Mode
Procedure to Boot When
the BOF is Present Locally
Procedure to Boot in the
Satellite Mode
Procedure to Boot in the
Standalone-VC Mode
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Description
This procedure uses the auto-init mode to boot the
7210 SAS device.
This procedure uses the manual mode to boot the
7210 SAS device. In manual mode, the device can be
booted from the local flash or it can be booted from the
network using an uplink port or the OOB Ethernet
management port. The following procedures apply:
• Procedure to Boot from the Image on Flash in Manual
Mode
This procedure uses the manual mode to boot the
7210 SAS device from the local flash.
• Procedure to Boot from the Network in Manual Mode
Using Uplink Ports
This procedure uses the manual mode to boot the
7210 SAS device from the network using an uplink
port.
• Procedure to Boot from the Network in Manual Mode
Using the OOB Ethernet Management Port
This procedure uses the manual mode to boot from
the 7210 SAS device from the network using the OOB
Ethernet management port.
This procedure uses the BOF that is present locally to boot
the 7210 SAS device.
This procedure boots the 7210 SAS device in the satellite
mode.
This procedure boots the 7210 SAS device in the
standalone-VC mode.
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA