Nokia 7210 Configuration Manual page 548

System Management
Parameters num-resources — Specifies the number of resources. Specifying the def keyword
eth-cfm
Syntax eth-cfm num-resources
no eth-cfm
Context configure>system>resource-profile>ingress-internal-tcam
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates resources for CFM Up MEPs, CFM Down MEPs, ingress MIPs, and
bidirectional MIPs (ingress and egress MIPs).
Note: On most 7210 SAS platforms, ingress MIPs and bidirectional MIP resources are
allocated from the Down MEP and Up MEP resource pool. See the
commands for more information.
The no form of this command specifies that the software does not allocate any resources for
use by CFM UP MEPs, and it will allocate the default amount of resources for CFM Down
MEPs.
Parameters num-resources — Specifies the maximum number of resources available for use by
Table 58
548
specifies the default number of resources.
Values 0 to 2, def
Default 0
ETH-CFM.
Values Table 58
Number of Resources Available for ETH-CFM
Platforms
7210 SAS-M (per node)
7210 SAS-T Access-Uplink mode (per node)
7210 SAS-T Network mode (per node)
7210 SAS-R6 (per IMMv1)
7210 SAS-R6 and 7210 SAS-R12 (per
IMMv2)
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
lists the parameter values.
Min value
(per node)
0
0
0
1
1
© 2021 Nokia.
Configuration Guide
down-mep and up-mep
Max value Default
(per node)
1 0
1 0
1 0
3 1
3 1
3HE 17358 AAAB TQZZA