Nokia 7210 Configuration Manual page 510

System Management
Description Commands in this context configure Link Layer Discovery Protocol (LLDP) parameters on the
specified port.
dest-mac
Syntax dest-mac {bridge-mac}
Context config>port>ethernet>lldp
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures destination MAC address parameters.
Parameters bridge-mac — Specifies destination bridge MAC type to use by LLDP.
admin-status
Syntax admin-status {rx | tx | tx-rx | disabled}
Context config>port>ethernet>lldp>dstmac
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command specifies the administratively desired status of the local LLDP agent.
Parameters rx — Specifies that the LLDP agent will receive, but will not transmit LLDP frames on this
tx — Specifies that the LLDP agent will transmit LLDP frames on this port and will not
tx-rx — Specifies that the LLDP agent will transmit and receive LLDP frames on this port.
disabled — Specifies that the LLDP agent will not transmit or receive LLDP frames on
notification
Syntax [no] notification
510
Values nearest-bridge — Specifies to use the nearest bridge
nearest-non-tpmr — Specifies to use the nearest non-Two-Port
MAC Relay (TPMR)
nearest-customer — Specifies to use the nearest customer
port.
store any information about the remote systems connected.
this port. If there is remote systems information which is received on this port and
stored in other tables, before the port's admin status becomes disabled, the
information will naturally age out.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA