Transport; Transport Within A Building; Transportation Between Two Buildings - Bosch WS502 Instruction Manual

36/64 Bosch Rexroth AG
Transport and storage
8.2

Transport

8.2.1

Transport within a building

Note during transport:
General
Make sure the doors and entrances are sufficiently wide.

Remove attachments and sets that are not required beforehand.

Transport the WS502 training system only with a pallet truck or forklift.

Do not transport any other objects or persons together with the WS502

training system.
Transport Perform the following steps:
Turn the main switch on the control cabinet to the "OFF" position.

Remove the plug from the power socket and store the mains cable.

Disconnect the cables connected to the hand control on the connection

module.
Remove the compressed air supply.

Tipping hazard of the WS502 training system! It is possible that the centre of
gravity is off-centre; the centre of gravity shifts depending on the attachments!
Risk of injury when lifting and transporting!
Secure the training system when lifting and transporting in order to prevent

tipping.
Lift the WS502 training system only with a forklift truck or lift truck.

Transport the WS502 training system to the new space.

8.2.2

Transportation between two buildings

General Note during transport:
Make sure the doors and entrances are sufficiently wide.

Remove attachments and sets that are not required beforehand.

Transport the training system only with a pallet truck or forklift.

Do not transport any other objects or persons together with the WS502

training system.
Transport Perform the following steps:
Turn the main switch on the control cabinet to the "OFF" position.

Remove the plug from the power socket and store the mains cable.

Disconnect the cables connected to the hand control on the connection

module.
Remove the compressed air supply.

Robotics Trainings System WS502
CAUTION