Input Command Processing - Bosch Conettix D6600 Manual

Conettix D6600/D6100IPv6/D6100i | Computer Interface Manual | 3.0 Computer Communication
Protocols
.
3.3

Input Command Processing

Input devices, such as automation systems, send the commands described in Table 94 to the receiver.
If the receiver does not recognize a command, it generates a REJECT COMMAND message, prints at
connected printers, and sends an ASCII text message to the automation port.
The CPU programming in Menu Item 2.2.4 of the D6600/D6100/D6100IPv6 Receiver must be set
to 1 to use input commands.
Table 94: ASCII Text Message to Automation Port
Set The automation system, or other device, sends the command shown below to set the
Time time at the D6600/D6100/D6100IPv6 if the D6600/D6100/D6100IPv6 is programmed to
synchronize the time and date with the automation system.
D6650
Mode:
SIA
Mode:
Set Date The automation system, or other device, sends the command shown below to set the
date at the D6600/D6100/D6100IPv6 if the D6600/D6100/D6100IPv6 is programmed to
synchronize the time and date with the automation system.
D6650
Mode:
SIA
Mode:
Stop The automation system, or other device, sends the command shown below to stop a
Two two way audio session on the line specified.
Way
D6650
Audio
Mode:
SIA
Mode:
Reject D6650
Comma Mode:
nd
SIA
Mode:
Table 95: Input Command Output Messages
D6500 Mode
Set Time h1rrssssssssssssXss2t
Set Date h1rrssssssssssssXss51t
Stop h1rrssssssssssssXss52t
Two Way
Audio
Table 95 shows the D6500 and SIA automation output formats for these input commands.
Bosch Security Systems, Inc. | 2012.09 | 4998122703-05
!Thhmm<CR>
<seq><rec><line>[CSThhmm]<CR>
hh - hours (24 hour format)
mm – minutes.
!Dmmddyy<CR>
<seq><rec><line>[CSDmmddyy]<CR>
mm - month, dd - day, yy – year
!Kn<CR>
<seq><rec><line>[CLKnn]<CR>
nn - line card number, 01-32.
h3rrlsREJECTsCOMMANDsst
<LF><CRC><TAB><sequence#><receiver#><line#>[REJECT COMMAND]<CR>
SIA
Mode
[NJT]
[NJD]
[CLK]
Printer Output
TIME SET
DATE SET
TWO WAY AUDIO STOP STOP
77