GE T2100 Service Manual page 51

Procedure
Check Emergency Stop
(ESTOP) Switch
Check Handles
Refer to
Handles" on page
Communicate with Host
Can Host control elevation
and speed?
Noise and Vibration
Vibration
Rattling or Growling
Thumping
2021403-120F
Indicate
Pass/Fail
"Double-Check
52.
T2100 Treadmill
If Failed, perform the following:
1. If belt does not stop, make
sure emergency stop switch
is connected to back of the
T2100 Treadmill.
2. Call tech support.
Tighten handle fasteners.
1. Check that interface cable is
properly connected.
2. Replace interface cable.
3. Use the T2100 Treadmill
Diagnostic Utility (TDU) to help
troubleshoot the problem. See
"T2100 Treadmill Diagnostic
Utility (TDU)" on page
See "Location of Major
Sub-Assemblies" on page 107
to identify these assemblies.
1. Check drive belt and walking
belt tension. See "Walking
Belt Tracking And Tension
Adjustment" on page
2. Check for loose bolts and
broken welds.
3. Check the fly wheel.
4. Check the drive pulley on
motor.
5. Make sure the roller assembly
bolts are tight.
1. Check for loose bolts.
2. Check lithium grease on
elevation racks.
3. Check drive motor and
elevation motor.
Check drive belt and walking belt
tension.
See "Walking Belt Tracking And
Tension Adjustment" on page 54
Installation
Indicate
Pass/Fail
78.
54.
.
51