Installation
6.
Make sure all screws and bolts are seated properly and no sharp edges are
present.
7.
Reassemble the shroud and align the grommets properly.
Install Emergency Stop Switch
NOTE:
The emergency stop switch must be installed and the ESTOP cable plugged in to
the T2100 Treadmill connection panel for the T2100 Treadmill to operate. If the
ESTOP is not installed, the T2100 Treadmill will not operate.
1.
Attach the two clamp pieces to the assembled, latching emergency stop switch.
2.
Position the clamps around the T2100 Treadmill front handrail and secure with
the supplied screw and nut. The emergency stop switch can be mounted in
different locations and positions based on customer preference.
3.
Connect the cable from the emergency stop switch to the connection on the
T2100 Treadmill's rear connector panel. (See
connection locations.)
4.
Use the cord clips to attach the cable along the front handrail and secure the
excess cable.
42
Item
Description
1
Emergency Stop Switch Assembly
2
Cable
3
Clamp
4
Handrail
T2100 Treadmill
"Connection Panel" on page 35
for
2021403-120F